Process Parameter Interaction Study for Epoxy/Kenaf Composites Preparation via Two-Level Full Factorial Approach

Jeefferie Abd Razak; Noraina Alia Mat Noor; Noraiham Mohamad; Rosidah Jaafar; Mohd Muzafar Ismail; Ramli Junid; Poppy Puspitasari

doi:10.37934/mjcsm.1.1.1126

Authors

Jeefferie Abd Razak Fakulti Kejuruteraan Pembuatan, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
Noraina Alia Mat Noor Fakulti Kejuruteraan Pembuatan, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
Noraiham Mohamad Fakulti Kejuruteraan Pembuatan, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
Rosidah Jaafar Fakulti Kejuruteraan Pembuatan, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
Mohd Muzafar Ismail Fakulti Kejuruteraan Elektronik & Kejuruteraan Komputer, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, 76100 Durian Tunggal, Melaka, Malaysia
Ramli Junid Faculty of Mechanical Engineering, Universiti Malaysia Pahang, 26600, Pekan, Pahang, Malaysia
Poppy Puspitasari Mechanical Engineering Department, Fakultas Teknik, Universitas Negeri Malang, Jl. Semarang, No. 5, Malang, 65145, Jawa Timur, Indonesia

DOI:

https://doi.org/10.37934/mjcsm.1.1.1126

Keywords:

Full Factorial, Interaction Study, Kenaf Fiber, Epoxy, Solution Mixing, High Speed Mechanical Stirrer, Optimization

Abstract

This study was conducted to understand the interaction involved between the process parameters of the solution mixing for the preparation of epoxy/kenaf composites via two-level full factorial approach. There are three (3) independent variables which are the kenaf fibre loadings (-5.00 wt.%; +35.00 wt.%), stirring period (-10.00 mins; +50.00 mins) and the stirring speed (-100 rpm; +700 rpm), involved in this work. A set of 2³ full factorial design with three replication at a center point and no block was applied to yield a total of 11 set of experiments. The DesignExpert 6.0.8 statistical software has optimized the resulted tensile strength (TS) response as dependent variable of prepared epoxy/kenaf composites. It was found that the optimum processing parameter are at 100 rpm of stirring speed, 10 mins of the stirring period and about 5.00 wt.% of the kenaf fiber loading, with the highest coeficient of determination R² value of 99.9%. Fracture surface morphological observation via SEM has been performed to correlate further the interaction between the processing variables toward an optimum resulted TS response. In overall, this study has significance to facilitate manual processing of natural fiber based epoxy composite started at the early integration between the kenaf fiber as reinforcement phase and epoxy as the matrix phase, using a high speed mechanical stirrer apparatus.