An Investigation of Three-Way Catalytic Converter for Various Inlet Cone Angles Using CFD

Authors

  • Sohel Khalil Shaikh Department of Mechanical Engineering, Hi-Tech Institute of Technology, Aurangabad, Maharashtra 431001, India
  • Khizar Ahmed Pathan Department of Mechanical Engineering, Trinity College of Engineering and Research, Pune, Maharashtra, 411048, India
  • Zakir Ilahi Chaudhary Department of Automobile Engineering, M.H. Saboo Siddik College of Engineering, Mumbai, Maharashtra, 400008, India
  • B. G. Marlpalle Department of Mechanical Engineering, Deogiri Institute of Engineering and Management Studies, Aurangabad, Maharashtra, 431001, India
  • Sher Afghan Khan Mechanical Engineering Dept., Faculty of Engineering, International Islamic University Malaysia, Kuala Lumpur, Selangor, 50728, Malaysia

DOI:

https://doi.org/10.37934/cfdl.12.9.7690

Keywords:

Automotive catalytic converter, diffuser angle, monolith diameter, flow index, pressure drop

Abstract

Three-way catalytic converters are utilized to minimize exhaust emissions. The efficient working of catalytic converter depends upon the flow field developed inside the converter. Due to the prevailing stringent norms, such as Bharat stage-VI, it is essential to create and design a high performing converter having uniform flow distribution within the converter to meet these norms. An easy way to gain an almost sufficiently homogeneous stream circulation is to compose the diffuser inclination minimally and correspondingly to manufacture the cone angle length long enough. The objective of the study is to examine an automobile catalytic convertor to present a detail and comprehensive report on the key parameters affecting the flow uniformity inside the converter and thus attempting to achieve minimum pressure drop across the converter to reduce the backpressure. They are modifying the existing geometry of the catalytic converter to have more uniform flow within the convertor. The analysis had been carried out with varying diffuser angles- 57.3, 52.3, and 45 degrees separately. Simulation program using computational fluid dynamics (CFD) software package STAR CCM + 11.02 was used. The monolith design with a 52.3º cone angle evaluated with computations provides an actual parabolic curve, which gives a laminar flow within the catalytic converter, which in turn will increase the conversion efficiency of the converter by 1.060 %. The pressure drop within the monolith is also reduced by 3.7 Pa. This accounts to be a reduction in backpressure up to 5%, thus reduces brake specific fuel consumption of automobiles. The results are validated with the literature. The result shows the overall pressure drop augments with velocity. The temperature effect on light-off performance also studied.

Downloads

Published

2020-11-17

How to Cite

Shaikh, S. K., Pathan, K. A., Chaudhary, Z. I., Marlpalle, B. G., & Khan, S. A. (2020). An Investigation of Three-Way Catalytic Converter for Various Inlet Cone Angles Using CFD. CFD Letters, 12(9), 76–90. https://doi.org/10.37934/cfdl.12.9.7690

Issue

Section

Articles

Most read articles by the same author(s)

<< < 1 2