Study on Mechanical Properties of Pla Printed using 3D Printer

Mohd Fakhrur Razi  Misran; Mohd Sarhan  Othman; Za'aba Helmi  Khamisan

Study on Mechanical Properties of Pla Printed using 3D Printer

Authors

Mohd Fakhrur Razi Misran Department of Mechanical Engineering, Politeknik Kuching Sarawak, Malaysia
Mohd Sarhan Othman Department of Mechanical Engineering, Politeknik Kuching Sarawak, Malaysia
Za'aba Helmi Khamisan Department of Mechanical Engineering, Politeknik Kuching Sarawak, Malaysia

Keywords:

PLA, tensile test, Taguchi Method, 3D printer

Abstract

The aims of this study are to investigate the tensile strength of polylactic acid (PLA) material using Taguchi Method and to evaluate the best parameters which have the highest significant impact on the tensile properties of PLA. Three parameters are used to investigate the tensile properties of PLA which include printing speed, infill pattern, and layer thickness. The PLA filament is printed using a 3D printer. The printed parts are tested under tensile test according to standards ASTM test samples. The number of experiment is determined by using Taguchi method. Based on the ANOVA analysis, optimum parameter for the tensile strength of PLA are obtained through validation test. The ANOVA analysis shows that the significant variable is infill pattern which gives highest impact on tensile strength.

Downloads

PDF ¹⁰⁸

Published

2020-11-02

How to Cite

Misran, M. F. R. ., Othman, M. S. ., & Khamisan, Z. H. . (2020). Study on Mechanical Properties of Pla Printed using 3D Printer . Journal of Advanced Research in Applied Mechanics, 59(1), 10–18. Retrieved from https://akademiabaru.com/submit/index.php/aram/article/view/1844