Cylindrical and Row Trenched Cooling Holes with Alignment Angle of 90o at Different Blowing Ratios

Authors

  • Ehsan Kianpour Faculty of Mechanical Engineering, Universiti Teknologi Malaysia 81310 UTM Johor Bahru, MALAYSIA
  • Nor Azwadi Che Sidik Faculty of Mechanical Engineering, Universiti Teknologi Malaysia 81310 UTM Johor Bahru, MALAYSIA
  • Mazlan Abdul Wahid Faculty of Mechanical Engineering, Universiti Teknologi Malaysia 81310 UTM Johor Bahru, MALAYSIA

Keywords:

gas turbine, film-cooling, cylindrical hole, trenched hole, blowing ratio

Abstract

This study was carried out to find out the effects of two different blowing ratios of BR=1.25 and BR=3.18 on the film cooling performance adjacent the combustor end wall, whereas two different cooling holes arrangements as cylindrical and row trenched cooling holes with alignment angle of 90 degree are considered. In this research, a three-dimensional presentation of a true Pratt and Whitney aero-engine was simulated and analyzed with a commercial finite volume package FLUENT 6.2.26 to gain fundamental data. The current study has been performed with Reynolds-averaged Navier-Stokes turbulence model (RANS) on internal cooling passages. This combustor simulator combined the interaction of two rows of dilution jets, which were staggered in the stream wise direction and aligned in the span wise direction. The entire findings of the study declared that with using the row trenched holes near the enwall surface; film cooling effectiveness is doubled compared to the cooling performance of baseline case.

Downloads

Published

2021-01-18

How to Cite

Kianpour, E. ., Che Sidik, N. A. ., & Abdul Wahid, M. . (2021). Cylindrical and Row Trenched Cooling Holes with Alignment Angle of 90o at Different Blowing Ratios. CFD Letters, 5(4), 165–173. Retrieved from https://www.akademiabaru.com/submit/index.php/cfdl/article/view/3373
سرور مجازی ایران Decentralized Exchange

Issue

Section

Articles

Most read articles by the same author(s)

1 2 > >> 
فروشگاه اینترنتی